Shopping Bag

0 item(s) in cart/ total: $0    view cart

Directions For Use

Directions for Using your new 510 E-Cigarette:
1. Screw together your cartomizer and battery. DO NOT OVER TIGHTEN. OVER TIGHTENING CAN CAUSE BATTERY FAILURE.
2. While holding down the black button, draw a slow mouthful and inhale.
3. The batteries have a cut off timer built into them. If you take too long of a drag, the light at the tip of the battery will flash and you will have to wait 10 seconds to take another drag.
4. If the light blinks every time you push the button, it is time to recharge your battery.
5. If you notice a flavor change or allot less vapor, and your battery is fully charged, it is time to refill or replace your cartomizer.

Directions for Charging your new E-Cigarette:
1. Screw together your battery and usb charger. 
2. Plug the battery/usb charger into your computer or any available usb port.
3. The indicator light will turn red while the battery is charging. And it will turn green when charging is complete.
4It takes approximately 2 hours to completely charge your battery.
5. Never leave your battery on the charger for more than 12 hours.
6. Never use any charger other than the charger supplied with your kit!

How to Refill Cartomizers:
1. Hold the cartomizer with the battery connection end facing down and the mouth-piece facing up. 
2. Remove the rubber cap at the mouthpiece. 
3. Hold at an angle and add drops into the cartomizer. Let the liquid seep into the filament around the hole. 
4. A new empty cartomizer can hold approximately 20 drops of liquid. We recommend not adding more than 12-15 drops to a prefilled cartomizer because it may leak. 
5. Cover both ends of the cartomizer with a rag or the provided caps and shake it up to spread liquid evenly inside cartomizer.
6. Make sure the cartomizer is not over filled by looking into the hole. If you can not see through the hole, the cartomizer is over filled and will not vape properly and strain the battery. If overfilling occurs, place a rag on the mouthpiece and blow into it from the end with the connector. Look again to make sure the center is clear.
7. Wipe off excess liquid from the center hole and its ready to vape!. 
8. If you get any liquid on your hands, wash them immediately.

Directions for using the eGo Pass-through kit.

How to charge and use battery

To charge the battery, unscrew the front cap to reveal the charging port. plug the small end of the usb cord into the front of the battery, then plug the larger end into a usb port. the front of the battery will glow red while the battery is charging and go out when charging is complete.

 To turn the battery on or off , press the clear button 5 times fast. the light will blink to indicate that the battery is on. press and hold the battery while vaping, release button when your done taking your "drag". Please make sure to only use the charger that was provided with your e-cigarette. Failure to do so could result in Fire, Injury, or Death.

Filling up your CE4

Filling up your CE4 clearomizer is fairly straightforward. You can fill a CE4 with a standard drip tip e-liquid bottle, Remove the mouthpiece by unscrewing counter-clockwise

  1. Hold the CE4 clearomizer at a 45 degree angle and begin dripping e-liquid along the inside wall of the unit until it is filled to just below the bottom of the rubber cover inside of the unit. It will hold approximately 1.6ml of e-liquid from empty.
  2. Replace mouthpiece and screw it in clockwise